DBC800 - Duraboot® CV Boot Kit

Manufactured from high quality neoprene the Duraboot® is resistant to:

Oil & grease,
Extremes of temperature,
Tear and impact damage.

The design of the boot allows for superior flexibility minimalizing wear and tear especially when the vehicle is on full lock.

Can be fitted to trilobal/tripod joints, follow the simple step by step instructions below.

Can be fitted using the conventional cone method. Alternatively the boot can be stretched using either of our innovative tools, Duragun® or Duralec®, which will enable the job to be fully completed in only 20 minutes, a fraction of the conventional time.

Covered by our 2 year ‘no quibble’ guarantee.


Price £11.04 +VAT - Call to purchase (DO NOT add to basket)

✔ Available from all good Distributors and Motor Factors

£9,999.99 ex VAT

< Return to products


  • 1x Duraboot® CV boot
  • 2x Stainless steel ear clamps
  • 1x Grease sachet


Fitting Instructions


 Trilobal Fitting


  • Clean the outside of the old boot at the CV joint, large end, using a suitable cleaner.
  • Trim the old boot approximately 10-15mm from the end of the CV joint; leaving the trilobal part of the boot in position. (See diagram)
  • Remove the old clamps and boot leaving the trilobal section in place on the CV joint.
  • Clean away any grease and debris from the shaft and CV joint, as normal.
  • Wipe the outside of the remaining section of the trilobal boot, attached to the CV joint, to ensure that all grease and debris has been removed enabling a good seal to be obtained.
  • Fit the new CV boot in the usual way, clamping the large end over the trilobal adaptor that has been created from the old boot.

Related Products

£158.96 +VAT
£197.77 +VAT
FCONE Fitting Cone FC1
£10.89 +VAT
ECLMPP Ear Clamp Pliers ECP1
£32.08 +VAT
ECLMP Ear Clamps MC1&MC2
£2.34 +VAT

Customers also viewed

Web Design by Thomas Cole Digital
Copyright © 2015 Bailcast Ltd. Unit 8, Chorley North Industrial Park, Chorley, Lancashire, PR6 7BX, England