Made from the same high-quality compound as our CV and Steering rack boots the Ball Joint Covers are flexible and extremely hardwearing.

The innovative design and shape ensure that the maximum number of ball joints are covered from only 4 sizes.

Profitable - minimal stock investment required
Superior stretch capabilities compared to natural and synthetic rubber boots
Resistant to oil & grease, abrasion, grit and extremes of temperature
Tear and impact resistant

Whilst some spare part distributors/suppliers would advise the replacement of the full ball joint, if the cover is split, in a lot of instances this isn’t either necessary or cost effective.

Replacing the cover is a simple job especially when using the Easifit tool.

Replacing the cover, instead of the full track rod end, means there is no need to check or adjusted the steering geometry saving both time and money.

Available from all good Distributors and Motor Factors